*Note 4) When the pressure gauge is attached, a 1.0 MPa will be fitted for standard (0.7‑MPa setting) type; 0.4 MPa for the 0.2‑MPa type (1.0‑MPa pressure gauge only for the AR10-A). *Note 5) Pressure can be set higher than the specification pressure in some cases, but use with the pressure within the specified range. *Note 6) Thread type
Digital flow switch (59 pages) Switch SMC Networks PFMC7501-L Operation Manual. Digital flow switch (98 pages) Switch SMC Networks PFMC7-L Series Manual. Digital flow switch (32 pages) Switch SMC Networks PFMC Series User Manual. (12 pages) Switch SMC Networks SMC TigerStack 1000 SMC8724M Management Manual. Smc networks gigabit ethernet switch For models with 2 outputs, [P_2] or [n_2] will be displayed. Set as above. The Pressure switch operates within a set pressure range (from P1L to P1H) during window comparator mode. Set P1L (switch lower limit) and P1H (switch upper limit) using the setting procedure above. output. When reversed output is selected, [n1L] and [n1H] are displayed.
Pressure switch Clean gas filter Flow control equipment Filter, Pressure control equipment Air preparation equipment 2-Color Display Type High-Precision Digital Pressure Switch 10-ZSE30/ISE30 Dimensions 925 Panel mount Panel mount adapter + front protective cover R4.5 34.5 47.8 21 7.2 17.8 8 8.75 9.5 Panel thickness 0.5 to 6 11 34.5 42.4 Panel
•A response time for switch output can be set as user desires. •Set the optimum response time to prevent the chattering of a switch. The response time currently set will be displayed. Select a desired resp ontim by g h u . Press the button to set . 1 20 160 640 1280 7.Pressure setting •There are two methods for pressure set-up : manual Pressure switch with piping adapter X201 X202 X250 Length of lead wire: 3m Reverse mounting (Left side mounting style) Setting pressure range: 0.1 to 0.6MPa — Y YL YT — N F Without attachment With attachment With attachment and L type bracket With attachment and T type bracket Pressure switch applicable model No. Y type standard Rc(PT) NPT Low Differential Pressure Sensor. Voltage output: 1 to 5 V. PSE550 . The intended use of thepressure sensor is to measure the pressure of fluids and provide an analogue output signal. 1 Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of
1 Instruction manual for assembly and maintenance with positioners SMC. 2 CONTENTS page 1. - Generalities Scope Basic characteristics Air consumption Operation Components Setting up Transport and installation Supply Maintenance Preventive maintenance Recommended replacements Maintenance and use of the reservoir and accessories Appendix
Set pressure range –100.0 to 100.0kPa –101.3 to 101.3kPa –1.000 to 1.000MPa Model 10-ZSE40F-- 10-ZSE40--10-ISE40--Note When equipped with auto shift function, the following ranges can be set. High precision digital pressure switch 10-ZSE40/ISE40 NPN or PNP open collector output: 2 outputs Maximum load current 80mA
.
